 |
RC4000M
Reel Control Specifications |
|||
| Input Voltage | 115 or 230 VAC; single
phase; 50/60 Hz; +/- 15% |
Modular Antennas | click thru to antenna page for size and selection |
|
| Power Consumption | 1200 VA | Coupler | epoxy encapsulated impervious to water, dirt & oil |
|
| Coupler Cable | 8 feet (2.4m) standard longer lengths available |
|||
| Motors | directly drives DC shunt wound and
permanent magnet motors up to ½ HP / 90 volt armature up to 1 HP / 180 volt armature | |||
| Enclosure | NEMA 12, plastic
10.2 " L x 7.8 " W x 4.0 " D (259mm x 199mm x 102mm) |
|||
| Interlocks | auto: allows on/off
control of the reel motor by processing equipment - JOG active
shutoff: allows on/off control of the reel motor by processing equipment - JOG inactive |
Mounting | vertical or horizontal - to any bulkhead, chassis or panel | |
| Weight | 6.0 lbs. (2.7 Kg) | |||
| Environment | unaffected by dirt, grease, vibration, etc. | |||
| temperature: 0° F - 130° F | ||||
| humidity: 0 - 95% R. H. | ||||
| Keypad Controls | Select (in setup mode): push to select reel or dereel mode, antenna position, and high and low limit relay activation | Indicators | Bargraph: displays loop height relative to antenna | |
| Enter (in setup mode): push to lock in SELECT settings | Limit Lights: lit when loop height exceeds control range | |||
| Tune (in setup mode): push to tune the system | Run Light: on when motor function is active - in AUTO or JOG | |||
| Jog (in setup mode): push and
release to nudge motor push and hold to run motor |
Tune Light: flashes when
tuning is required on while unit is tuning flashes with fault light on to indicate antenna fault |
|||
| AUTO/SETUP: push to toggle between Setup and Auto modes | Fault Light: indicates a loss of antenna or internal fault | |||
| Adjust Up / Down (in setup mode): allow motor-on, realtime loop height adjustment | Selection Indicators: for reel/dereel, antenna position, and high and low limit relay activation, the indicators flash to show they are available for selection. Use the SELECT key to step through the choices. Use the ENTER key to set each choice. Indicators stay lit to show how the unit is configured. | |||
